ZM-C电脑中频治疗仪清洗与消毒
Clean and disinfection
电极板前面的布垫每次用完后应用清水清洗干净后，再用沸水煮5分钟消毒。
Cloth electrode plate in front of each pad after use clean water after application, and then cook in boiling water for 5 minutes disinfection.
建议：布垫应使用一次性制品或专人专用，防止交叉感染。
Suggested: The cloth pad should use the disposable product or the specialist special-purpose, prevents the cross infection.
故障分析及排除
故障现象
原因分析
排除方法
备注
开机后无显示
电源插座接触不良
检查插座
保险管击穿
换保险管
电源线不同
更换电源线
治疗强度加不上去，仪器即蜂鸣
治疗电极插口处接触不良（两端）
检查插口是否牢固（注意两端）
治疗电极已离开人体
治疗电极接触好治疗区域
?????????
Breakdown phenomenon
Reason analysis
Elimination method
Remarks
Boot no display
Bad power supply socket
Check the socket
The protective tube penetrates
Trades the protective tube
Power cord barrier
Replace the power line
Treatment intensity does not add up, apparatus that buzz
Treatment electrode receptacle place bad contact (both sides)
Check whether the socket firmly?(attention both sides)
Treatment of the electrode had left the body
Treats the electrode to contact the good treatment region
如仍不能排除故障，请按保修卡上的联系方式和本公司联系，切不可打开主机，以免损坏其他部件。 ???????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????
If still could not?rule out the fault, please click on?the warranty card ?in Contacts and contact the Company, must not open the console in order to avoid damage to other components.
