中频治疗仪操作方法
- 重要建议
- 本机最大输出电流为90mA±10℅；本机使用的电极9.7×6.7(cm2）；其最大输出电流密度：100mA÷（9.7cm×6.7cm）=1.54mA/ cm2
The local maximum output current is 90mA ± 10 ℅; the local use of electrodes 9.7 × 6.7 (cm2); its maximum output current density: 100mA ÷ (9.7cm × 6.7cm) = 1.54mA / cm2
- 当使用电极小于9.7×6.7(cm2）时，电流密度≥2mA(r.m.s)/ cm2,要特别注意输出强度和患者的承受力。
When using the electrode is less than 9.7 × 6.7 (cm2), the current density ≥ 2mA (rms) / cm2, to pay special attention to the output intensity and patient's tolerance.
- 治疗用硅胶电极属消耗品，正常使用下每年需更换一次，更换电极应与本公司联系。
The treatment is the consumables with the silica gel electrode, under the normal use every year must replace one time,?the replacement of electrode contact with the Company.
- 操作程序
- 接通电源（2），插好输出线和电极（3）、（4）（一定要插牢）；打开电源开关（6），处方指示（8）亮，数码窗口（9）显示处方序号； 按动增加键（12）或减少键（13），选择治疗处方。
Connected to power (2), plug the output lines and better electrode (3), (4) (must want interpolation cachots) ;?Turns on the power switch (6), prescription instruction (8) bright, the digital window (9) demonstrates the prescription serial number;?Pressed the increase in bond (12) or reduce the bond (13), the choice of treatment prescription.
- 在患者治疗部位固定好治疗电极；??
?按动功能选择键（10），时间指示（11）亮，数码窗口（9）显示治疗时间，按动增加或减少键选择治疗时间；再按动功能选择键（10），黄色治疗指示（14）亮，数码窗口（9）显示治疗强度。按动增加或减少键，调节治疗强度，以患者的耐受量为准。
In patients with good treatment of parts of fixed electrode;
Presses the function choice key (10), time instruction (11) bright, the digital window (9) demonstrates the treatment time, presses increases or the reduced key choice treatment time;
???Presses the function choice key again (10), yellow treatment instruction (14) bright, the digital window (9) demonstrates the treatment intensity. ?Pressed the increase or decrease button, adjusting the treatment intensity, patient's tolerance to prevail.
- 治疗程序完成后，自动恢复至处方状态，并有蜂鸣提示，取下电极，关断电源，治疗完毕。
After the treatment procedure completes,?automatically restore to prescription status, and there is buzz prompted, remove the electrodes, power shutdown, treatment has finished.
注：当黄色治疗指示（14）亮时，按增加键，即有电流输出。
Note: When the yellow treatment instruction (14) is bright, presses increases the key,?that is, there is current output.
?
